geronimo

welcome Screendog,, tight lines and may the wind stay at your back..!!!

Dfree.. the top picture needs to be repaired,, its not a big job at all,, cant really see the second picture,, but this repair wont cost much now,, dont take a chance with the gel coat chaffing more and chipping away from the original ding any further,,, not sure if water intrusion will become an issue,, while its small fix it..

Check the factory wiring panel..to see if its clean and the install looks proper, check the gel coat for cracks,,check the transom for holes and cracks,, check the deck for cracks,, check the stainless screws for rust seeping (low quality Stainless weeps), pull the engine cover and inspect the engines,,remember this is a 2006 likely built in late 2005 so its been sitting somewhere for almost 3/4 years,, open every hatch and cover, make sure while underway the steering cables are adjusted properly. And by the way open that baby up and see what it will do while it belongs to them..!!!!

If one on those boats belongs to your sister , and the other to your mother,,,Then,,,You might be a Redneck..!

Try walking around that boat.. or TUB..!

Betcha a dollar to a donut,, Water intrusion and delamination is your problem.. Its not a new problem at all .. but a pain in the ass for sure..!

Not all walkarounds are created equal.. seatrial and actually try using the walkaround ..some boats walk easier then others,, some have a recessed walkway some have an extended deck,, some have the grab rail raised.. some dont,, you gotta walk the boat while you still have the cash.. after you purchace your stuck,, seatrial the walkaround and see if its all you thought it would be..

It like Gatorade for Manatees.!

great customer service.. its hard to beat.. !

Another vote here for Ocean Waves.. i have had the same pair of Ocean Waves for over 10 years ( yeah i know) but i have had to send them back because the frames got funky, no issues at all ,,new frames same lens. second time the lens fell out and again no issues no cost.. fast shipping,, They are GREAT.

Good water pressure , dual feed muffs,, and the tilt will do it..!

Read your posts on THT,, What a Dead Beat.. Hope it works out for you,,thanks for the Heads up..!

I think the F-250 calls for a 10 hour service. There is not much to it. Oil and filter and a once over for torqueing of bolts if required (not really an issue). My f-250 was a real treat trying to get a good flow of water from the hose muffs. Use care...! Great motor..!

Woody Wax,,and dont look back..!

glad we have another "not internet brands site" my old screen name was ngirolamo. lets support this site as we have inthe past..!

hey guys ,, made the trip over from THT. was a senior member there, and was with Wiley and THT group for a couple of years,, Glad to be back..!!!