Console Redo

[kingair]

I was able to get the console done this weekend. I need to buff out a few places where the Imron paint left some grainy residue.

I was able to attach the 2 doors, refit the C 120 and gauge console, add the 2 drink cups and plumb them. I also installed the all the electronics and power distro box.

I had a setback with the top canvas,as it arrived with grommets that were not set properly. The die was unable to punch through the web backing, so that is being redone.

The panel that holds the fresh water tank was fiberglassed in and stringers were added to give it support. I purchased and drain so if water is released, it will drain to the bilge.

Here are some pictures.

Before

After

[Fishinspot]

That turned out very good. I bet your excited. Thanks for putting all your work onto the forum for us to see!

Thanks again!

[seavee1]

looks great!! Dont mean to ask a stupid question, but is there any interfer with the ss cup holders and the compass?

It looks great

[aitkenkingfish]

thats comming out great. cant wait to see it in the boat.

[kingair]

looks great!! Dont mean to ask a stupid question, but is there any interfer with the ss cup holders and the compass?

It looks great

I did not notice any movement when the cups were installed and dry fitted, however you are able to compensate by use of the deviation rods.